Use an existing configuration file when you upgrade to a new XTM device [Fireware XTM v11.4.x]
Posted by Samuel Turi on 03 May 2011 11:39 AM

Use an existing configuration file when you upgrade to a new XTM device [Fireware XTM v11.4.x]


To use an existing configuration file for a new XTM device, you must first configure the new XTM device with a basic configuration. Then you can save the existing configuration to the new XTM device. Some changes must be made to the existing configuration before you save it to the new XTM device.

To move a configuration file from one Firebox X e-Series or XTM device to another device model, you must complete these steps in Policy Manager:

  • Remove feature key for the old model from the configuration file.
  • Add the feature key for the new model to the configuration file.
  • Review the network interface configuration, and update it if necessary.
  • Save the configuration to the new XTM device.

For more information and more detailed instructions, see Use an existing configuration for a new XTM model.

If your old device is a Firebox X Core and Firebox X Peak device that is not an e-Series model, the upgrade steps are different. For more information, see Update a Non-e-Series Configuration File For Use With an e-Series or XTM Device

(0 vote(s))
Helpful
Not helpful

Comments (0)
Post a new comment
 
 
Full Name:
Email:
Comments:
CAPTCHA Verification 
 
Please enter the text you see in the image into the textbox below (we use this to prevent automated submissions).