Knowledgebase: Watchguard Support
Reset an XTM device to factory default settings [Fireware XTM v11.4.x]
Posted by Samuel Turi on 03 May 2011 11:06 AM

Reset an XTM device to factory default settings [Fireware XTM v11.4.x]

If your WatchGuard XTM device has a severe configuration problem, you can reset the device to its factory-default settings. For example, if you do not know the configuration passphrase or if a power interruption causes damage to the Fireware XTM OS, you can use the Quick Setup Wizard to build your configuration again or restore a saved configuration.

For more information, see:

(13 vote(s))
Not helpful

Comments (0)
Post a new comment
Full Name:
CAPTCHA Verification 
Please enter the text you see in the image into the textbox below (we use this to prevent automated submissions).